Building a Gardner Douglas 427 AC Cobra replica classic sports car: November 2019

Friday, November 01, 2019

Update

Sorry I haven’t posted recently regarding the hood. This is because I could not stretch the fabric around the moulding no matter how much I tried or heated it. As a result and following a conversation with Andy at GD, the hood fabric has been sent back to the trimmers to ease the stitching holding the piping in place. This appeared to be stopping the fabric from stretching around the moulding and so it was about 50mm (2 inches) short at each side!

How to use this blog

This is a record of my Cobra sports car build. If you want to create a Cobra too, this step by step diary may help you or simply give you some advice on how to go about it.

The blog is not an official GD site and is not endorsed by them, nor does the blog indicate that I endorse the GD product in any way. It is simply a record of what I did.

If you are interested in the build process, then just look at the posts in chronological order. My blog shows the most recent posts first. Look out for the 'Older posts' link at the bottom of any page.

If you are interested in a specific area of the build e.g. brakes, then click on 'Brakes' under 'Build process' and you will just see stuff about the brakes. Do look at the "Things that went wrong" category to see lessons that I learned the hard way during the build. Where possible I have added a note to the relevant post too. Remember that the posts are shown with the newest first.

Should you want to see other people's builds, suppliers or other elements please just click on the appropriate link provided below.