Under dash trays and dashboard plus door seal finishers

At last, some work after a break doing some housework! Well work on the new house. So I am back to building the Cobra after almost a three month lay off. Yes I did a few small jobs, but now it's down to it properly.

Some essential, but easy jobs first. The bonnet was secured properly. The pivot bolts were re-attached, as were the gas struts. Next the remaining caphead bolts and washers were used to secure the hinges to the bonnet.

Then the wires were extended to attach to the horn. A tie wrap secured the wires to the compressor to ensure that they do not flap about.

Wires tie wrapped to compressor

Under dash trays

I had already fitted the centre under dash tray (see a previous post) a while back. The centre tray is where the ECU will sit.

The outer trays were secured to the front cross brace (the brace nearest the bulkhead) using self tapping screws. This will allow access to the dash if needed, at a later date. I had been putting this off. I thought that dodging the swarf from drilling the holes would be difficult. It wasn't as the holes could be drilled without getting right under the dash, I simply leaned in to the footwell and drilled the holes.

Hole in the underside of dash tray drilled through to the cross brace

The outer trays were fixed to the front brace only.

Under dash tray secured by self tapper

They were temporarily held at the dashboard end by racing tape. The trays will be sandwiched between the dashboard bottom and the rear most cross brace (nearest the driver/passenger).

The footwell heater outlet holes are pre-cut in the GD panels, but the laser cut holes were too small for the plastic vent, so needed opening out. I used the electric drill and a burr.  Here one part of the vent pushes through the hole, securing with the flexible lugs. Two small slots in the trays and squares on the vent stop them swivelling. The other part clicks over the vent on the upper side.

Driver's side vent in place

The other side is handled in the same way.

Door seal finishers

I have decided to replace the door seal finishers. I was not happy with those bought from Europa having seen the GD items. The GD finishers are not cheap, but they are good!

Front nearside door seal finisher in place

The rear door seal finishers will take a little more thinking about before I can fit them!